Victron Phoenix Smart inverter 12/1600 230V – With plug & play cable set

This new model Victron Phoenix inverter 12/1600 230V Smart supplies 230V AC household appliances with the correct power from DC batteries. With this pure sine wave DC/AC inverter, 12 V DC is converted into 230 V AC for devices with a continuous power rating under non-linear load of 1600 VA (1300 W with a peak power of 2400 W). The inverter features integrated Bluetooth and a VE.Direct communication port. Thanks to Bluetooth, the inverter can be controlled via smartphone, tablet or PC through the Victron Connect App for information and settings.

Integrated Bluetooth : fully configurable with a tablet or smartphone • Low battery voltage alarm
• Low battery shutdown and restart levels
• Dynamic shut-down: load-dependent shut-down level
• Output voltage: 210 – 245 V • Frequency: 50 Hz or 60 Hz
• ECO mode on/off and ECO mode detection level
• Alarm relay

Monitoring
• Input and output voltage, load and alarms

VE.Direct communication port
The VE.Direct port can be connected to a computer (VE.Direct to USB interface cable required) to configure and monitor the same parameters.

Proven reliability
The full-bridge and toroidal transformer topology has proven its reliability over many years. The inverters are short-circuit proof and protected against overheating, whether caused by overload or high ambient temperature.

High starting power
Required to start loads, such as power converters for LED lamps, halogen lamps or power tools.

ECO mode

In ECO mode, the inverter switches to standby when the load drops below a preset value. In standby, the inverter briefly turns on every 2.5 seconds (adjustable). If the load exceeds a preset level, the inverter remains on.

Remote on/off
An external on/off switch can be connected to a two-pole connector. Alternatively, the H terminal (left) of the two-pole connector can be connected to the battery positive, or the L terminal (right) of the two-pole connector can be switched to battery negative (or, for example, to the chassis of a vehicle).

LED diagnostics
Refer to the manual for a description.

To transfer the load to another AC source: the automatic transfer switch
For our low-power inverters, we recommend our Filax Automatic Transfer Switch. The Filax has a very short switching time (less than 20 milliseconds), allowing computers and other electronic equipment to operate without interruption. Alternatively, use a MultiPlus with integrated transfer switch.